Коды ошибок кондиционеров AUX
Коды ошибок бытовых серий кондиционеров (сплит-систем AUX)
E1 |
Room temperature sensor fault Ошибка датчика температуры в помещении Temperature sensor of air intake fault - для серии LK on-off |
E2 |
Outdoor coil temperature sensor fault Ошибка датчика (термистора) испарителя наружного блока Temperature sensor of outdoor coil fault - для серии LK |
E3 |
Indoor coil temperature sensor fault Ошибка датчика (термистора) испарителя внутреннего блока Temperature sensor of indoor coil fault - для серии LK on-off |
E4 |
Indoor fan motor or DC motor feedback fault Неисправность PG двигателя PG motor of indoor unit feedback fault - для серии LK on-off Indoor fan motor feedback fault - для серии LK on-off 36 модель, серии F |
E5 |
Indoor & outdoor communication fault Ошибка (неисправность) наружного блока |
F0 |
Outdoor DC Fan motor fault Неисправность двигателя вентилятора |
F1 |
IPM modular fault Неисправность модуля (платы) IPM |
F2 |
PFC modular fault Неисправность модуля (платы) PFC |
F3 |
Compress or operation fault |
F4 |
Exhaust Temperature sensor fault Неисправность датчика температуры |
F5 |
Compressor top cover protection Защита верхней крышки компрессора |
F6 |
Outdoor ambient temp sensor fault Неисправность датчика температуры наружного воздуха |
F7 |
Over/under voltage protection Защита от повышенного / пониженного напряжения |
F8 |
Outdoor modular communication fault |
F9 |
Outdoor E²PROM fault |
FA |
Suction temperature sensor fault (4-way valve swich failure) для серий J, D inverter, Kids Неисправность датчика температуры всасывания (отказ переключателя 4-ходового клапана) Suction temperature sensor fault - для серий D on-off, LK invertor Неисправность датчика температуры всасывания в кондиционере |
Коды ошибок полупромышленных кондиционеров AUX (Аукс)
модели ALCa, ALCe, ALHi (R22, серия С2)
Ошибка |
Светодиодная индикация на внутреннем блоке |
Индикация на проводном пульте |
Состояние системы Ошибка связи |
Ошибка связи |
нет |
Е5 |
Остановлена |
Авария дренажа1 |
Светодиод таймера (желтого цвета) мигает 4 раза |
Е4 |
Остановлена |
Перефазировка2, пониженное напряжение питания2 или низкое давление в системе3 |
Светодиод таймера (желтого цвета) мигает 6 раз |
Е6 |
Остановлена |
Неисправность датчика комнатной температуры |
Мигает светодиод таймера (желтого цвета) |
Е1 |
Остановлена |
Неисправность датчика температуры на испарителе |
Светодиод таймера (желтого цвета) мигает 2 раза |
Е3 |
Остановлена |
Неисправность датчика температуры на конденсаторе |
Светодиод таймера (желтого цвета) мигает 2 раза |
нет |
Работает |
Режим размораживая наружного блока |
Мигает светодиод работы (зеленого цвета) |
нет |
Работает |
Коды ошибок на полупромышленные кондиционеры Аукс
Error |
Error code definition |
Recovery or not |
Problem possible reasons |
E0 | Lack of refrigerant | No |
Compressor internal protection System is short of refrigerant Reversing failure of 4 way valve Возможные причины: внутренняя защита компрессора, в системе не хватает хладагента, обратный отказ 4-ходового клапана |
E1 | TA (lndoor temperature sensor) is abnormal | Yes |
Sensor damage Poor contact of sensor |
E2 |
TW(Defrosting temperature sensor) is abnormal |
Yes |
Sensor damage Poor contact of sensor |
E3 | TE(lndoor coil sensor) is abnormal | Yes |
Sensor damage Poor contact of sensor |
E4 | Drainage system failure | Yes |
Damage of water pump Damage of water level switch Water level switch is locked |
E5 | Communication failure of wired controller | Yes |
Communication wire sequence error Poor contact of communication wire |
E6 | Outdoor unit protection(phase sequence) | No |
The power cable phase is missing Power cable phase sequence error |
E7 |
TL(Outdoor condensing temperature sensor) is abnormal |
Yes |
Sensor damage Poor contact of sensor |
E8 |
TP(Discharge temperature sensor) is abnormal |
Yes |
Sensor damage Poor contact of sensor |
E9 | Low pressure protection | Yes | System is short of refrigerant |
EA |
Outdoor unit protection (Discharge temperature is too high) |
No | External protection device action |
F1 |
Communication failure between indoor unit and outdoor unit |
Yes |
Communication wire sequence error Poor contact of communication wire |
F2 | Exhaust overtemperature protection | Yes |
System is blocked or fault of the outdoor fan |
F3 | Outdoor fan is abnormal | Yes |
Poor contact of outdoor motor Motor is broken |
F4 | Indoor fan is abnormal | Yes |
Poor contact of indoor motor Motor is broken |
F5 |
Outdoor temperature sensor is abnormal |
Yes |
Sensor damage Poor contact of senso |
F6 | Compressor overcurrent protection | No |
Compressor is blocked Low voltage |
F7 | Dial switch is abnormal | Yes | Wrong position of dial switch |
FB | Indoor power protection | Yes | Wrong wiring |
F9 | High pressure protectio | Yes |
Condenser is blocked Abnormal operation of the outdoor fan System pipe is blocked |